Never replace the lamp assembly or any electronic component unless the projector is unplugged.
Excessive use of lamps beyond the rated life could cause them to break on rare occasions.
Do not use lamps beyond the rated lamp life.
Allow the projector to cool for approximately 45 minutes prior to removing the lamp assembly for replacement.
The lamp becomes extremely hot during operation.
Do not block the projection lens with any objects when the projector is under operation as this could cause objects to become heated and deformed or even cause a fire.
Always open the lens shutter or remove the lens cap when the projector lamp is on.
The intense light beam may damage your eyes.
Do not look straight at the projector lens during operation.
Do not use if the projector is tilted at an angle of more than 10° degrees left or right, nor at an angle of more than 15° degrees forwards or backwards.
The projector may fall over, causing personal injury or projector malfunction.
Do not place the projector on an uneven or unstable surface.
Do not place anything on the projector that prevents heat dissipation.
Place the projector in a well-ventilated area.
Allow at least 20“ (50 cm) clearance around the projector to ensure proper ventilation.
Read all warnings and follow all instructions.
Keep this user guide in a safe place for later reference.
Please read the following Safety Precautions before you start using the projector.
Product Disposal at End of Product Life.
Indian Restriction of Hazardous Substances.
PJLink™, SNMP, AMX and Xpanel Formats Supported.
Controlling the Projector through a Web Browser.
Controlling the Projector through a LAN Environment.
Adjusting the Projector's Height and Projection Angle.